ELECTRIC FIREPLACE HEATERINSTRUCTION MANUALQCM650-38A-OAKNDF-65NB-3ATTENTION: 1. Find a location for the fireplace heater that is protected from dire
10MAINTENANCE WARNING: Disconnect power and unplug the power cord before attempting any maintenance or cleaning to reduce the risk of fire, electric
11REPAIR SETREPAIR SETTOUCH UP REPAIR PAINT1.Paint directly on the mantel unit if necessary. Fig. Afig. AREPAIRSIf any problems are found with the ori
12fig. EOption 2: Use the SMALL L-BRACKETS and SCREWS1. Place the SMALL L-BRACKET to the unit as shown and mark the drill-holes on the mantel as shown
13WARRANTYpower source. Light bulbs are not covered by this warranty. The warranty is for homeowner use only and does not cover units used in commerci
2WHEN USING ELECTRICAL APPLIANCES, BASIC PRECAUTIONS SHOULD ALWAYS BE FOLLOWED TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, AND INJURY TO PERSONS, INCL
315) Avoid the use of an extension cord because the extension cord may overheat and cause a risk of fire. However, if you have to use an extension cord
4WARNING: Procedures and techniques if not carefully followed - will result in damage to the equip-ment. - will expose the user to the risk of serious
5ASSEMBLY INSTRUCTIONSPARTS LIST:A) Top panel 1B) Base panel 1C) Decorative bar 1D) Upper-front panel 1E) Lower-front panel 1F) Lef
6ASSEMBLY INSTRUCTIONSStep 2: Attach the LEFT SMALL PANEL (H) to the LEFT FRONT PANEL(F) with 2 KD SCREWS. Attach the RIGHT SMALL PANEL (J) to the RIG
7Step 7: Attach the DECORATIVE BAR (C) over the UPPER FRONT PANEL (D) and attach with 2 KD SCREWS (1 screws each side). See Fig. GStep 8: Attach the L
8mantle opening. The front of the INSERT should be flush with the front of the mantle.Step 3: Once the INSERT is in place, attach 3 MOUNTING CLIPS (R)
9OPERATIONAfter reading complete instructions, confirm all controls on fireplace are in the OFF posi-tion. Plug the fireplace into a 15AMP/120Volt outlet
Comments to this Manuals