ELECTRIC FIREPLACE HEATERINSTRUCTION MANUALM850P-36ACNNDF-65NB-1ATTENTION: 1. Find a location for the fireplace heater that is protected from direc
10OPTION 1: Use the spare KD NUTS, KD SCREWS and PLASTIC CONNECTOR1. Place the PLASTIC CONNECTOR on the mantel unit and mark the drill-holes as shown
114. Attach the PLASTIC CONNECTOR and lock in place with KD SCREWS as shown in Fig. E.OPTION 2: Use the SMALL L-BRACKETS and SCREWS.1. Place the SMALL
12WARRANTYEvery electric fireplace heater is tested before it leaves the factory and it is guar-anteed for one year. If the unit should fail to operate
2SAFETY INSTRUCTIONSIMPORTANT Please note when you open the carton care-fully check the unit and make sure there are no damages. If you have any prob
38) Do not run cord under carpeting. Do not cover cord with throw rugs, runners, or similar coverings. Arrange cord away from traffic area and where it
4heater. If the breaker trips when the heater is used then you may need to move the heater to another location or unplug other appliances that are on
5MANTEL AND INSERT ASSEMBLY:WARNING: Make sure the fireplace INSERT controls are in the OFF position and the INSERT is NOT plugged in. CAUTION: Place a
6NOTE: If the KD SCREW(S) do not fit during assembly, loosen the 2 screws to adjust the PLASTIC CONNECTOR until the PANELS/KD SCREWS can be installed.
7Step 8: Attach 3 MOUNTING CLIPS [U] onto the top of INSERT and lock in place with 3 SHORT KD SCREWS [T]. See Fig. H.Step 9: Install the TOP PANEL [A]
8OPERATIONAfter reading complete instructions, confirm all controls on fireplace are in the OFF posi-tion. Plug the fireplace into a 15AMP/120Volt outlet
9DIMMER CONTROL KNOB: Turn the dimmer dial clockwise or counter clockwise to get the desired flame intensity. The dimmer switch can only be used when t
Comments to this Manuals